Optimization of Two–Mass Electromechanical System

Authors

  • B. Karaliūnas Vilnius Gediminas Technical University

Abstract

The issues of two – mass electromechanical optimization are analyzed. The probable methods of optimization and measures were discussed. The structural diagram of system optimization is presented, it is comprised of DC motor with two – mass mechanical link Matlab/Simulink model, PID regulator and units of signal limitations. The optimization process is finalized, when the characteristics of transitional process corresponding the proposed parameters are derived. The results obtained indicate that after determining the optimal values of the amplifying coefficients for the regulator during the optimization it is possible significantly reduce the oscillations of drive velocity, acceleration, current and torque and obtain optimal dynamic characteristics.

Downloads

Published

2010-08-24

How to Cite

Karaliūnas, B. (2010). Optimization of Two–Mass Electromechanical System. Elektronika Ir Elektrotechnika, 103(7), 43-46. Retrieved from https://eejournal.ktu.lt/index.php/elt/article/view/9273

Issue

Vol. 103 No. 7 (2010)

Section

ELECTRICAL ENGINEERING

License

The copyright for the paper in this journal is retained by the author(s) with the first publication right granted to the journal. The authors agree to the Creative Commons Attribution 4.0 (CC BY 4.0) agreement under which the paper in the Journal is licensed.

By virtue of their appearance in this open access journal, papers are free to use with proper attribution in educational and other non-commercial settings with an acknowledgement of the initial publication in the journal.