New Approach to Calibration of Vertical Fuel Tanks

Authors

  • V. Knyva Kaunas University of Technology
  • M. Knyva Kaunas University of Technology
  • J. Rainys Kaunas University of Technology

DOI:

https://doi.org/10.5755/j01.eee.19.8.5391

Keywords:

3D laser scanning, fuel tank calibration

Abstract

Recalibration of the vertical fuel tanks must be done once in 5 years. Fuel tank during its usage can be affected by geological or other reasons (for example it may be damaged during installation or repair). So Volume chart of the tank can be corrupted. For calibration of vertical fuel tanks in Lithuania and in all EU, mix of geometrical and liquid filled methods is used. In this article a new approach to calibration of vertical fuel tanks, based on 3D laser scanning and data processing, will be presented.

DOI: http://dx.doi.org/10.5755/j01.eee.19.8.5391

Downloads

Published

2013-10-07

How to Cite

Knyva, V., Knyva, M., & Rainys, J. (2013). New Approach to Calibration of Vertical Fuel Tanks. Elektronika Ir Elektrotechnika, 19(8), 37-40. https://doi.org/10.5755/j01.eee.19.8.5391

Issue

Vol. 19 No. 8 (2013)

Section

ELECTRONIC MEASUREMENTS

License

The copyright for the paper in this journal is retained by the author(s) with the first publication right granted to the journal. The authors agree to the Creative Commons Attribution 4.0 (CC BY 4.0) agreement under which the paper in the Journal is licensed.

By virtue of their appearance in this open access journal, papers are free to use with proper attribution in educational and other non-commercial settings with an acknowledgement of the initial publication in the journal.