Reconfigurable Two-Current Source Supplied Signal Conditioner for Resistive Sensors

Authors

  • Wojciech Walendziuk
  • Adam Idzkowski
  • Jerzy Golebiowski

DOI:

https://doi.org/10.5755/j01.eie.22.2.14587

Keywords:

Measurement techniques, sensor systems, error analysis.

Abstract

The principle of operation, its practical realization and measurement research of a reconfigured system of a signal conditioner are presented. A two-sourced conditioner supplied by direct current with four resistance sensors and four switching keys was experimentally tested. In the example application the resistance of sensors in the function of the same point load, caused by perpendicular force, was measured. In order to compare the results achieved with the use of a conditioning circuit, similar tests were carried out for a four-channel Wheatstone’s bridge-based commercial acquisition card. The research aimed at confirming the possibility of implementing the constructed signal conditioner in cheap measurement equipment.

DOI: http://dx.doi.org/10.5755/j01.eie.22.2.14587

Downloads

Published

2016-04-05

How to Cite

Walendziuk, W., Idzkowski, A., & Golebiowski, J. (2016). Reconfigurable Two-Current Source Supplied Signal Conditioner for Resistive Sensors. Elektronika Ir Elektrotechnika, 22(2), 27-32. https://doi.org/10.5755/j01.eie.22.2.14587

Issue

Vol. 22 No. 2 (2016)

Section

ELECTRONIC MEASUREMENTS

License

The copyright for the paper in this journal is retained by the author(s) with the first publication right granted to the journal. The authors agree to the Creative Commons Attribution 4.0 (CC BY 4.0) agreement under which the paper in the Journal is licensed.

By virtue of their appearance in this open access journal, papers are free to use with proper attribution in educational and other non-commercial settings with an acknowledgement of the initial publication in the journal.