The Automated Complex Impedance Measurement System

Authors

  • V. Dumbrava Kaunas University of Technology
  • L. Svilainis Kaunas University of Technology

Abstract

The design of automated, low cost, complex impedance measurement system is described. The overview of impedance measurement methods is given and suitable candidates outlined. The I–V method and the auto–balancing bridge method have been selected and the system structure has been adopted for those two methods. The preliminary investigation results for both methods are presented. The parallel RC circuit and transducer BVD electrical model have been used as test impedance. The measurement results are plotted against theoretical impedance value. The piezoactuator impedance variation versus load was measured as demonstration of system monitoring capabilities. Ill.9, bibl.12 (in English; summaries in English, Russian and Lithuanian).

Downloads

Published

2007-04-19

How to Cite

Dumbrava, V., & Svilainis, L. (2007). The Automated Complex Impedance Measurement System. Elektronika Ir Elektrotechnika, 76(4), 59-62. Retrieved from https://eejournal.ktu.lt/index.php/elt/article/view/10720

Issue

Vol. 76 No. 4 (2007)

Section

T 121 SIGNAL TECHNOLOGY

License

The copyright for the paper in this journal is retained by the author(s) with the first publication right granted to the journal. The authors agree to the Creative Commons Attribution 4.0 (CC BY 4.0) agreement under which the paper in the Journal is licensed.

By virtue of their appearance in this open access journal, papers are free to use with proper attribution in educational and other non-commercial settings with an acknowledgement of the initial publication in the journal.